Yocto/GettingStarted: Difference between revisions
< Yocto
| Line 1: | Line 1: | ||
= Getting Started = | = Getting Started = | ||
This page is supposed to give a simple to follow guide of the first steps one have to do to assemble a setup for embedded development, preparing a first build via Yocto, build it and test-run it on the development device. | |||
== Material Needed == | == Material Needed == | ||
Revision as of 14:04, 16 July 2023
Getting Started
This page is supposed to give a simple to follow guide of the first steps one have to do to assemble a setup for embedded development, preparing a first build via Yocto, build it and test-run it on the development device.
Material Needed
Embedded development always have the problem that you need some material additional to a development computer.
The most important components that one always should have:
- development board
- power supply for the development board
- micro SD card as main storage of the development board
- a micro SD card writer/reader
- a RS232-USB adapter for low level debugging of startup problems of the development board
Preparation for Yocto Build
TODO