Alkimia/Development Environment: Difference between revisions

Revision as of 20:39, 28 June 2011

DEVELOPMENT ENVIRONMENT

First of all you will need to install the LibAlkmia which first needs some requirements to be fulfilled as follows

Qt Creator or KDevelop4 (personally, I find Qt Creator easier to grasp, even if less powerful in the end)
KdeSVN
Qt libs and docs
KDE libs and docs
automoc
GMP (this is for mathematical calculations needed for the currency class)
Boost libs
cmake

After finishing the installations as mentioned above you need to follow the steps as follows ( I have mentioned the codes according to the Ubuntu)

Open the terminal and change the directory where you want the files to be downloaded.
Use the svn link to download the files
```
svn co svn://anonsvn.kde.org/home/kde/trunk/extragear/office/alkimia
```
Note: It might give an error " svn: Unknown Hostname 'anonsvn.kde.org'" , but just ignore it and try again as there is a network problem or the anonsvn server might be out.
Now you will have the directory Alkimia downloaded with a lot of files.
Change the current directory to libalkimia(present inside the Alkimia directory)
```
cd alkimia/libalkimia
```
Make another directory
```
mkdir build
```
I have named my directory as build
Change your current directory to 'build'
```
cd build
```
Now build that directory using the files you have in the folder 'libalkimia' using the following commands
```
cmake ..
```
If every requirement listed above were installed perfectly then there must not be any error here
```
make
```
```
make install
```
The above two statements could also have been combined into one and be simply written
```
make install
```

If you didnt get any error till now, then you have installed the libalkimia successfully

@@ Line 26: / Line 26: @@
 #:<syntaxhighlight lang="bash">cmake ..</syntaxhighlight>
 #:If every requirement listed above were installed perfectly then there must not be any error here
-#:<syntaxhighlight lang="bash">make</pre>
+#:<syntaxhighlight lang="bash">make</syntaxhighlight>
 #:<syntaxhighlight lang="bash">make install</syntaxhighlight>
 #:The above two statements could also have been combined into one and be simply written
 #:<syntaxhighlight lang="bash">make install</syntaxhighlight>
 ;If you didnt get any error till now, then you have installed the libalkimia successfully